ES | Sitemap | RSS | XML

Customer consultation : 13827710288

通用banner

Advantages of aluminum profile double-end tractor

2019-10-09
Times

1. A saw mounted on the traction head near the extruder can be used to cut the profile at the stop mark or welding mark to reduce the waste of the profile.

2. The double-head traction system does not need to rely on the non-extrusion cycle to reschedule the expected next extrusion cycle.

3. Using PLC control technology, the tractor provides 9 different operating procedures to adapt to different extrusion modes.Easy to operate.

4. Double-head traction allows the traction head to operate at a low speed.

(1) due to the restriction of the length of 20 meters, the extrusion speed of the extruded profile is no more than 35m/min.

Return speed 220m/min.

(3) match non-extrusion time (invalid time) : 14 seconds.In the continuous production time of the extruder, the tractor affects the production efficiency of the extruder, that is, it is not allowed to wait for the return of the tractor.

In the traction, the control system can provide 1 KG increment change, traction adjustment range 0 ~ 250KG.

(5) the size of extruded profiles shall not be changed by the tractor in the process of traction, that is, the size of extruded profiles without traction and extruded profiles with traction shall be the same.

Traction flying saw saw cutting positioning accuracy: ±200mm;

5. As a system, the two-head tractor provides higher output while reducing waste.

6. The extrusion speed can be increased by 10-30% (if the die strength meets the requirements).

7. Increase production efficiency by 10-20%.

8. Product yield can be increased by 1-2%.


label

Recently Viewed:

Home   |   About   丨   Product   丨   Case   丨   News   丨   Inquiry   丨   Contact

© All rights reserved Foshan nanhai tongzheng machinery equipment co. LT
ICP 15042538 Service support:Up to the science and technology

1574905972646069.png

— Mobile station —

Share this site with others: